Sanyo PLC-XK2200 Owner's Manual page 65

at start-up.
not work.
appears on the screen
– Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
– PIN code lock is being set. Enter a PIN code (the "1234" or numbers
you have set). See pages 19, 53-54.
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector's code. See page 52.
– Unlock the Key lock function for the remote control function.
See page 53.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 69.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at
under of SETTING section. See page 53.
– Contact the dealer where you purchased the projector or the service
center.
– The projector detects an abnormal condition. Unplug the AC power cord
and contact the dealer where you purchased the projector or the service
center.
65