Sanyo PLC-XK2200 Owner's Manual page 12

Part Names and Functions
Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5
m) and 60 degrees in front of the projector.
The 2 different remote control codes (Code 1–Code
2) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment next
to each other are operated at the same time. Change the
remote control code for the projector first before changing
that for the remote control. See "Remote control" in the
Setting Menu on page 52.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and
Code 2. The initial code is set to Code 1.
12
Install new batteries
2
into the compartment.
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in compartment.
Replace the
3
compartment lid.
16.4'
(5 m)
30°
30° Remote control