Sanyo PLC-XK2200 Owner's Manual page 45

This function enables Input search, Auto Keystone
correction and Auto PC adjustment by pressing the
AUTO SETUP button on the top control or the AUTO
SET button on the remote control. Settings for those
functions can be altered as follows:
This function detects the input signal automatically.
When a signal is found, the search will stop. Use
the Point buttons to select one of the following
options.
......... Input search does not work.
On 1....... Input search works under the following
situation.
– When pressing the AUTO SETUP button
on the top control.
– When pressing the AUTO SET button on
the remote control.
On 2....... Input search works under the following
situation.
– When turning on the projector by pressing
the ON/STAND-BY button on the top
control or the remote control.
– When pressing the AUTO SET button on
the remote control.
– When pressing the AUTO SETUP button
on the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel
it to activate the Input search. It is also unavailable
when On-Screen menu is displayed.
On. . . . . . . Enables Auto PC Adjustment when
pressing the AUTO SET button on the
remote control or the AUTO SETUP button
on the top control.
. . . . . . Disables Auto PC Adjustment.
. . . . Always works and corrects keystone
distortion according to the projector's tilt.
Manual . . . Works only when pressing the AUTO
SETUP button on the top control or the
AUTO SET button on the remote control.
. . . . . . Disables Auto Keystone.
• While
status of Input and Lamp are displayed every time
the signal is switched.
• Only the last selected input source can be
detected.
is set to On 1 or On 2, the
• During is in progress, If the MENU
button or the ON/STAND-BY button is pressed,
will stop. If the COMPUTER 1/2
button or VIDEO or COMPONENT or S-VIDEO or VIDEO or COMPONENT or S-VIDEO VIDEO or COMPONENT or S-VIDEO
button is pressed,
back to the button's input signal.
• ,
can not be set at the same time.
• corrects vertical distortion only, not
correct horizontal distortion.
• The Auto Keystone function can not work when the
Ceiling feature is set On in the Screen menu (pp.
35, 43).
• Perfect correction of the image distortion can not
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP or the AUTO SET button, adjust
manually by pressing the KEYSTONE button on the
remote control or selecting
menu (pp. 23, 35, 43).
• ,
position of some computers cannot be fully adjusted
with the Auto PC Adjustment function. When the
image is not provided properly with this operation,
manual adjustments are required (pp. 30-31).
Setting
will stop and go
and
in the Setting
, and Vertical
45