Kyocera ECOSYS P7035cdn Operation Manual page 35

Setting
SMTP
POP3
Printing Operation
3
Enter the appropriate values to each field.
Description
Set to send e-mail from the machine.
Set SMTP protocol. Set the SMTP (E-mail TX) setting to On on
SMTP Protocol
the Protocol Settings page.
Enter the host name or IP address of the SMTP server.
SMTP Server
Name
Specify the port number to be used for SMTP. Use the SMTP
SMTP Port
default port 25.
Number
Set the amount of time to wait before time-out in seconds.
SMTP Server
Timeout
Set whether SMTP authentication is used. To use
Authentication
authentication, enter the user information for authentication.
Protocol
Set SMTP security.
SMTP Security
Turn on SMTP Security in SMTP (E-mail TX) on the
Protocol Settings page.
Specify the time in seconds until the connection to the POP
POP before
server times outs. This can be set when POP before SMTP is
SMTP Timeout
selected in Authentication Protocol.
Tests to confirm that the settings are correct.
Connection Test
Set whether or not domains are restricted. Click the Domain
Domain
List and enter the domain names of addresses to be allowed or
Restriction
rejected. Restriction can also be specified by e-mail address.
Set to receive e-mail at the machine.
Set POP3 protocol. Set the POP3 (E-mail RX) setting to On on
POP3 Protocol
the Protocol Settings page.
Specify the interval for checking for incoming e-mail in minutes.
Check Interval
Click Receive to connect to the POP3 server immediately and
Run once now
check for incoming E-mails.
Set whether or not domains are restricted. Click the Domain
Domain
List and enter the domain names of addresses to be allowed or
Restriction
rejected. Restriction can also be specified by e-mail address.
Configure the settings for POP3 user accounts and the POP3
POP3 User
server. You can configure up to three users.
Settings
2-9