Kyocera ECOSYS P7035cdn Operation Manual page 167

Auto Err. Clear: a b
1 *Off
2
On
Err. Clear Timer: a b
(5 - 495)
/**30-sec.
Using the Operation Panel
• RAM disk error.
• Incorrect account ID.
• Account error.
• Cannot duplex print on this paper.
• Job Accounting restriction exceeded.
• No multi copies.
• USB memory error.
• Restricted by Job Accounting.
• Job not stored.
For the procedure for setting the automatic error recovery time, refer to
Err. Clear Timer (Setting the error clear time) on page 4-95.
1
2
3
4
Err. Clear Timer (Setting the error clear time)
If Auto Err. Clear is set to On and a non-fatal error (an error that
allows printing to continue) occurs, this setting specifies the time until the
error is recovered and printing resumes. The default setting is 30
seconds.
1
2
M
3
4
In the Timer Setting menu, press  or  to select Auto Err.
Clear.
Press [OK]. The Auto Err. Clear screen appears.
Press  or  to select whether automatic error recovery is enabled.
Press [OK]. The automatic error recovery setting is set and the Timer
Setting menu reappears.
In the Timer Setting menu, press  or  to select Err. Clear
Timer.
Press [OK]. The Err. Clear Timer screen appears.
Use the arrow keys to set the recovery time.
Press  or  to increase or decrease, respectively, the value at the
blinking cursor.
Use  and  to move the cursor right and left.
Press [OK]. The recovery time setting is stored and the Timer Setting
menu reappears.
4-95