[*.*** Mm] Setting Blade Compensation; [** Gf] Setting Blade Force; [Smoothing] Cutting Smooth Curves - Roland Camm-1 PNC-1850 User Manual

*.*** mm
Display readout
1 CUT
0.250mm
Factory default setting
0.250 mm
Settings range
0 to 1.000 mm
(in increments of 0.025 mm)
** gf
Display readout
1 CUT
0.250mm
Factory default setting
30 gf
Settings range
30—500 gf
(in increments of 10 gf)
SMOOTHING
Display readout
SMOOTHING
OFF <ON>
Factory default setting
ON
Available settings
ON / OFF
24
Setting blade compensation
Explanation
This sets the amount of offset from the center to the
50cm/s
cutting tip of the blade. When cutting two lines that form a
30gf
corner, this offset rounds the angle of intersection,
resulting in a rounded corner.
When blade compensation has been set, the PNC-1850/
1200 performs this compensation automatically.
The setting must match the conditions of the loaded sheet and blade. Perform a
cutting test and make the appropriate settings.
It is sufficient if the setting made here is within an adjustment range of ±0.05 mm
from the offset value for the cutter blade. (For example, if the cutter blade is
0.250 mm, the setting should be between 0.200 and 0.300.)
The offset for the cutter blade included with the unit is 0.250 mm.
* When a pen has been installed to perform plotting, there is no need to set blade
compensation, because the tip of the pen lies along the center axis. In this case,
the setting "0.000 mm" should be made.
Procedure
This setting is made at the top menu.
Press
the lower line of the display.
Use
ENTER
For more details, refer to "1-4-5 Cutting Test" on page 15.
Setting blade force
Explanation
This sets the amount of pressure or force of the blade during cutting. The setting
50cm/s
must match the conditions of the loaded sheet and blade. Perform a cutting test
30gf
and make the appropriate settings.
Procedure
This setting is made at the top menu.
Press
the lower line of the display.
Use
ENTER
For more details, refer to "1-4-5 Cutting Test" on page 15.
Cutting smooth curves
Explanation
If you want the curves of circles and arcs to be cut smoothly, set this to "ON."
When on, however, small text or intricate designs may also be cut with rounded
corners. If this happens, change the setting to "OFF" and perform cutting again.
Procedure
At the top menu, press the
blinking cursor to "SUBMENU" on the right side of the lower line of the display,
and press
"SMOOTH" on the left side of the lower line of the display, and press
again. Change the value with
or to move the blinking cursor to " *.*** mm" on the left side of
and to change the value. Display the value for the setting and press
to save it.
or to move the blinking cursor to " *.*** mm" on the right side of
and to change the value. Display the value for the setting and press
to save it.
key once. Press
MENU
. Next, use or
ENTER
or
Center axis
Offset
or to move the
to move the blinking cursor to
and press to save the new setting.
ENTER
ENTER