Roland Camm-1 PNC-1850 User Manual page 27

MENU MENU
MENU MENU
Select [END.]
Press ENTER
PREFEED
Use
ORIGIN SET->ENTER
carreage and sheet to the position on the
0 0 sheet where the origin point is to be set.
Press
While PNC-1850 is
performing cutting
Press PAUSE .
X Y
0 0
MENU
UPDOWN TOOL-CHG UP DOWN
VS-CMND FS-CMND
Use or
to select.
PEN-CHG
(Align the blinking
cursor at the item.)
Press
ENTER .
VS-CMND
FS-CMND
MENU
Use or to select.
(Align the blinking
cursor at the item.)
Press ENTER .
COMMAND I/O
COMMAND
UNIT AREAUNIT
MENU
PREFEED END
Use or to select [PREFEED].
.
Press
ENTER .
AUTO PREFEED
<OFF> ON
OFF / ON
UNIT
, , , and to move the tool
ENTER to enable the setting.
CONT->PAUSE
AREAUNIT
STOP->ENTER
Continue cutting. Press PAUSE .
Abort cutting: Press ENTER .
Pressing ENTER
UP/DOWN->ENTER
Pressing ,
MOVE ->CURSOR
the +Y, -Y, -X, or +X directions, respectively.
TOOL-CHG COMMAND
<IGNORE> EFFECT
IGNORE / ACCEPT
Use
VS COMMAND
Press
<IGNORE> EFFECT
IGNORE / ACCEPT
FS COMMAND
<IGNORE> EFFECT
IGNORE / ACCEPT
Use or
to select.
Press ENTER to enable the setting.
When set to [SERIAL]
or [AUTO] (communicati
COMMAND MODE
on parameter setting)
1 2 <AUTO>
1 (mode 1) / 2 (mode 2) / AUTO
PROTOCOL 1
Use or to select.
STOP DATA PARITY
Press ENTER
to enable the setting.
INTERFACE
I/O
PARA SERI<AUTO>
PARA (Parallel) / SERI (Serial) / AUTO
Use or to select.
Press ENTER
to enable the setting.
MENU
DISPLAY UNIT
MENU
<MACHINE> MILI
MACHINE / MILI (Milimeter)
PROTOCOL 2
Use or
to select. BAUD
Press ENTER to enable the setting.
Use
AREA MENU UNIT
(Align the blinking cursor at the item.)
<METRE> FEET
Press
METRE / FEET
moves the blade up or down.
, , or moves the cutter in
or to select [IGNORE] or [EFFECT.]
ENTER
to enable the setting.
STOP BIT
STOP
<1> 2
1/2
DATA BIT
DATA
7 <8>
7 / 8
PARITY MODE
PRITY
<NONE>ODD EVEN
Use or NONE / EVEN / ODD
to select.
(Align the blinking
Press ENTER
cursor at the item.)
Press ENTER
BAUD BAUD RATE
19200 <9600>
BAUD RATE
4800 2400
2400 / 4800 / 9600 / 19200
HANDSHAKE
HAND-
SHAKE
HANDSHAKE
or to select.
<H-WIRE>XON/OFF
ENTER . H-WIRE (Hardwire) / XON/OFF
or
Use to select.
to enable the setting.