Installing The Cutter - Roland Camm-1 PNC-1850 User Manual

Connection
• Always make sure that the power is off on both the computer and the PNC-1850/1200 whenever any cables are
connected or disconnected.
• Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged and cause
failure during operation.
• Cables are available separately. One which you are sure matches the model of computer being used should be
selected.
Power outlet
Power cord

1-4-2 Installing the Cutter

• Always make sure the power switch is OFF before installing (or replacing) the cutter.
• Do not touch the tip of the blade with your fingers, as the cutting performance of the blade will be impaired.
Blade Holder (XD-CH2) Part Names
Push-pin
Scale
Cap
Cutter blade
Adjusting the Cutter Blade
The amount of cutter blade extension can be adjusted by rotating the cap. Turn the cap clockwise to retract the blade or counterclock-
wise to expose it. (Each scale line corresponds to 0.1 mm (about 0.004"). One full turn moves the blade 0.5 mm (about 0.02").)
Adjust blade holder before mounting on the tool carriage.
• If an ordinary sheet is to be used, tighten the cap all the
way (2.5 mm (about 0.098") of blade extension).
6
Serial connector
Parallel connector
Parallel interface cable or
Serial interface cable
Parallel connector
Serial connector
Installing a Blade in the Blade Holder
Insert a blade into the blade holder until it snaps into place with an
audible click.
* Take care not to break
or chip the blade.
Power connector [AC IN]
Push-pin
Blade holder
Blade
Tighten the cap until
there is no gap
Turn the cap
Amount of cutter blade
as shown by
extension: 2.5 mm
the arrow
(about 0.098")
(maximum length)