Roland Camm-1 PNC-1850 User Manual page 18

(5) Lift the sheet loading lever on the back of the unit to lower the pinch roller and clamp
the sheet.
Be sure to move the pinch rollers above the grit rollers when securing a sheet in the unit.
If you try to load a sheet with the pinch rollers at locations that are not above grit
rollers, the message shown at right appears on the control panel. If this occurs, raise the
sheet loading levers and move the pinch rollers to the proper positions above the grit
rollers.
Reposition the sheet to match this new alignment, then lower the sheet loading levers to hold the sheet in place.
(6) Secure the rolled sheet on the shafts by making sure that the two stoppers provisionally tightened in step (2) are aligned
exactly with the two sides of the rolled sheet, then tighten the stopper retaining screws securely.
(7) When you close the front cover, the message shown at right appears
on the control panel. Press
the key.
ENTER
(8) Press the key on the top menu once.
MENU
Press and align the blinking cursor with the "AREA" display
in the top left of the screen, then press
cursor to the numerals below "LENGTH," and change the value with
the and cursor keys. Always set the value to a minus value
here. To feed a 3 m sheet, for example, set the value as -3.0 m. Be sure
to set the length slightly longer the actual cut length you want. Next
press or to align the blinking cursor with the "MOVE" display
at the lower left of the screen. Press
length set in " LENGTH. "
Check the output sheet to make sure it is free of offset and alignment
problems, diagonal feed problems, and pinch roller handling prob-
lems.
If there are any of these problems, the sheet was not set straight.
Repeat the procedure over again, starting from step (3).
(9) Align with the front edge of the platen, and cut with
the separate cutter.
(10) In the same manner as in step (8), execute "MOVE". Feed the sheet to about the tool carriage position, toward the rear of the
PNC-1850/1200.
When the roll sheet is loaded from the front, the "PREFEED" function cannot be used to cut the sheet. Always
turn the "PREFEED" function off before operation.
Because the sheet is cut before the actual cutting data is sent, it is impossible to cut a length longer than the cut
length. Set the length to be fed toward the back with "MOVE" slightly longer than actually required.
12
or to display "ROLL," then press
. Move the blinking
ENTER
to feed the sheet by the
ENTER
Lift the sheet
loading levers
Change Pinch
Roller Position
Close the front cover
SELECT SHEET
ROLL EDGE PIECE
Top menu
1 CUT 50cm/s
0.250mm 30gf
Press twice.
MENU
AREA AXIS
REPLOT SUBMENU
Use or to select.
Press .
ENTER
AREA LENGTH
MOVE <-3.0m>
Use or to change the value.
Use to select "MOVE."
Press .
ENTER
Platen