Transaxle Range (Tr) Switch Removal/Installation - Mazda 6 2002 Workshop Manual

3. Disconnect the TR switch connector.
4. Inspect for continuity at the TR switch.
• If not as specified, adjust the TR switch and
go to Step 4.
5. Reinspect for continuity at TR switch.
• If not as specified, replace the TR switch.
(See K–15 TRANSAXLE RANGE (TR)
SWITCH REMOVAL/INSTALLATION.)
6. Connect the TR switch connector.
7. Install the air cleaner component. (See
INTAKE-AIR SYSTEM REMOVAL/
INSTALLATION.)
8. Connect the negative battery cable.
End Of Sie

TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See
Caution
• • • • Water or foreign objects entering the connector can cause a poor connection or corrosion. Be
sure not to drop water or foreign objects on the connector when disconnecting it.
3. Disconnect the TR switch connector.
4. Remove the clip and disconnect the selector
cable.
Caution
• • • • Do not use an impact wrench. Hold the
manual shaft lever when removing the
manual shaft nut, or the transale may be
damaged.
5. Set the adjustable wrench as shown to hold the
manual shaft lever.
6. Remove the manual shaft nut and washer.
AUTOMATIC TRANSAXLE
F–10
F–10 INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
A6E5614W008
K
A6E5614W010
A6E561419440W02
A6E5614W011
A6E5614W100
K–15