Pcm Configuration; Intake Air Temperature (Iat) Sensor Inspection - Mazda 6 2002 Workshop Manual

Hide thumbs Also See for 6 2002:
Table of Contents

Advertisement

PCM CONFIGURATION

1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle
recognition.)
3. Select “Module programming.”
4. Select “Programmable module installation.”
5. Select “PCM” and perform procedures according
to directions on the WDS screen.
Note
• If “PCM CONFIGURATION” is successful,
the PCM stores the DTC P0602 and
illuminates the MIL. (System is normal.)
Clear the DTC P0602 using WDS or
equivalent after “PCM CONFIGURATION.”
Note
• MIL goes off after three drive cycles with no failure. (DTCs remain in PCM.)
6. Retrieve DTC’s by the WDS or equivalent, then verify that there in no DTC present.
• If DTC is present, perform applicable DTC inspection.
End Of Sie

INTAKE AIR TEMPERATURE (IAT) SENSOR INSPECTION

Resistance Inspection
Note
• Perform the following inspection only when directed.
1. Disconnect MAF/IAT sensor.
2. Measure the resistance between the MAF/IAT
sensor terminals D and E using an ohmmeter.
• If not as specified, replace the MAF/IAT
sensor.
• If the MAF/IAT sensor is okay, but the IAT
PID are out of specification, perform the
“Circuit Open/Short Inspection”.
Specification
Ambient temperature (° ° ° ° C {° ° ° ° F})
–20 {–4}
20 {68}
60 {140}
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See
REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or
short. (Continuity check)
Open circuit
• If there is no continuity, the circuit is open. Repair
or replace the harness.
— MAF/IAT sensor terminal D (harness-side)
and PCM terminal 2E (harness-side)
— MAF/IAT sensor terminal E (harness-side)
and PCM terminal 2H (harness-side)
Short circuit
• If there is continuity, the circuit is shorted. Repair
or replace the harness.
— MAF/IAT sensor terminal E (harness-side) and power supply
— MAF/IAT sensor terminal D (harness-side) and power supply
— MAF/IAT sensor terminal D (harness-side) and body GND
End Of Sie
F–50
CONTROL SYSTEM
Resistance (kilohm)
13.6—18.4
2.21—2.69
0.493—0.667
F–43 PCM
A6E394018880W03
A6E3970W002
A6E394018845W01
A6E3940W005
A6E3940W006

Advertisement

Table of Contents
loading

This manual is also suitable for:

6

Table of Contents