Setting Up; Installation Mode; Parts For Ceiling Mount (Optional) - Panasonic PT-DZ16KE Operating Instructions Manual

Setting up

Installation mode

There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 95) depending on
the installation method. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING CONDITION] set incorrectly may shorten
the life of the lamp.
Mounting on the ceiling and projecting forward
Menu item
[PROJECTION METHOD]
[COOLING CONDITION]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
[COOLING CONDITION]

Parts for ceiling mount (optional)

You can install the projector on the ceiling using the optional Ceiling mount bracket (Model No.: ET-PKD510H (for high ceilings), ET-PKD510S
(for low ceilings)).
f Be sure to use the ceiling mount bracket specified for this projector.
f Refer to the Installation Instructions of the ceiling mount bracket when installing and setting up the projector.
Attention
f To ensure projector performance and security, installation of the Ceiling mount bracket must be carried out by your dealer or a qualified
technician.
Chapter 2 Getting Started — Setting up
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Method
[FRONT/CEILING]
[AUTO]
Setting on a desk/floor and projecting forward
Method
[REAR/CEILING]
[AUTO]
Menu item
[PROJECTION METHOD]
[COOLING CONDITION]
Menu item
[PROJECTION METHOD]
[COOLING CONDITION]
Method
[REAR/FLOOR]
[AUTO]
Method
[FRONT/FLOOR]
[AUTO]
ENGLISH - 35