Table of Contents
Advertisement
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f Data registered from a computer is not included in [ALL USER DATA].
[INITIALIZE]
Return various setting values to their factory default settings.
1)
Press as to select [INITIALIZE].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4)
Press as to select an item to initialize.
[ALL USER DATA]
[ENTRY SIGNAL]
[NETWORK/E-MAIL]
[LOGO IMAGE]
5)
Press the <ENTER> button.
6)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
[SERVICE PASSWORD]
This function is used by a service person.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns all setting values including [ENTRY SIGNAL], [NETWORK SETUP], [E-mail set up], and
[USER LOGO] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in "Deleting the
registered signal" (x page 115).
Returns [NETWORK SETUP] and [E-mail set up] to factory default settings.
Deletes the image registered in [USER LOGO].
ENGLISH - 111
Advertisement
Table of Contents
