[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] according to the projection direction, but set it to [AUTO] normally. Using the projector with incorrect setting may
shorten the life of the lamp.
1)
Press as to select [COOLING CONDITION].
2)
Press the <ENTER> button.
f The [COOLING CONDITION] screen is displayed.
3)
Press as to select a cooling condition.
f When [AUTO] is selected, the cooling conditions of [FLOOR SETTING], [CEILING SETTING], [VERTICAL UP SETTING], and
[VERTICAL DOWN SETTING] are set automatically.
You can check the setting from [COOLING CONDITION] on the [STATUS] screen.
4)
Press the <ENTER> button.
5)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
[HIGH ALTITUDE MODE]
Set this item to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea level.
1)
Press as to select [HIGH ALTITUDE MODE].
2)
Press qw to switch the item.
[OFF]
[ON]
3)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The speed of the fan increases and the operation sound becomes louder when set to [ON].
f This item cannot be set when using the optional Smoke cut filter (Model No.: ET-SFR510). (Setting is fixed to [OFF].) Use it at elevations
lower than 1 400 m (4 593') above sea level.
[LAMP SELECT]
Select the lamp to be lit from the four built-in luminous lamps according to the use conditions or purposes.
1)
Press as to select [LAMP SELECT].
2)
Press qw to switch the item.
[L1]
[L2]
[L3]
[L4]
[L1/L4]
[L2/L3]
[L1/L2/L3]
96 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
[VERTICAL UP SETTING]
30°
[FLOOR SETTING]
30°
[VERTICAL DOWN SETTING]
When using the projector at a location lower than 1 400 m (4 593') above sea level
When using the projector at high altitudes (between 1 400 m (4 593') and 2 700 m (8 858') above sea
level)
Lamp 1 will light.
Lamp 2 will light.
Lamp 3 will light.
Lamp 4 will light.
Lamp 1 and 4 will light.
Lamp 2 and 3 will light.
Lamp 1, 2, and 3 will light.
30°
[CEILING SETTING]
30°
:
Projection direction