Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1)
Press the <FOCUS> button to roughly adjust the focus of the image. (x page 51)
2)
Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] and [COOLING
CONDITION] depending on the installation mode. (x page 35)
f Refer to "Navigating through the menu" (x page 59) for the operation of the menu screen.
3)
Press the input selection (<RGB1>, <RGB2>, <DVI‑D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons to select
the input signal.
4)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 40)
5)
Press the <SHIFT> button to adjust the position of the image.
6)
If the input signal is an RGB signal, press the <AUTO SETUP> button.
7)
Press the <ZOOM> button to adjust the size of the image to match the screen.
8)
Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.
Note
f When the projector is switched on for the first time after purchase, as well as when [ALL USER DATA] is executed from the [PROJECTOR
SETUP] menu → [INITIALIZE], the focus adjustment screen is displayed after projection starts, then the [INITIAL SETTING] screen is
displayed. Refer to "Start-up display" (x page 24) for details.
3)
6)
4)
2)
1) 5) 7) 8) 9)
1) 8)
ENGLISH - 49
6)
3)
2)
5)
7) 9)
Advertisement
Table of Contents
