Running The Diagnostics From A Tty Terminal; Required Diagnostic Attributes - IBM H80 User Manual

v The CD-ROM drive from which diagnostics were loaded cannot be tested.
v The SCSI adapter (or circuitry) controlling the CD-ROM drive from which diagnostics
were loaded cannot be tested.

Running the Diagnostics from a TTY Terminal

Consider the following when you run diagnostics using a TTY-type terminal as the
console display:
v See the operator manual for your type of TTY terminal to find the key sequences you
need to respond to the diagnostics. For the 3151, refer to the 3151 ASCII Display
Station Guide to Operations , form number GA18-2633. For the 3164, refer to the
3164 ASCII Color Display Station Description , form number GA18-2617. For the
3153, refer to the Infowindow II 3153 ASCII Display User's Guide , form number
GA27-4084.
v When the diagnostics present information through the S1 serial port to the ASCII
display, certain attributes are used. These attributes are set as if the diagnostics
were using a 3161 display terminal. The following tables list attributes for the 3161
ASCII Display Terminal and for two other ASCII display terminals commonly used
with the system.
v If you have a TTY terminal other than a 3151, 3161, or 3164 attached to the S1
serial port, your terminal may have different names for the attributes. Use the
attribute descriptions in the following tables to determine the settings for your
terminal.

Required Diagnostic Attributes

The following attributes are the required default settings for the diagnostics. Be sure
your terminal is set to these attributes.
Note: Set these attributes before the diagnostics are loaded.
General Setup
Attributes
Machine mode
Generated Code Set
Screen
Row and filemn
3151 3151 3161/ 3164
/11/31/41 /51/61 Settings
Settings Settings
3151 3151 PC 3161 or
3164
ASCII
Normal Normal
24 x 80 24 x 80
Chapter 5. Using the Online and Standalone Diagnostics
Description
The diagnostics are set to
emulate use of the 3161 ASCII
Display Terminal. If your terminal
can emulate a 5085, 3161, or
3164 terminal, use the attribute
settings in this table. Otherwise,
refer to your operator's manual,
compare the attribute setting
descriptions in this table with
those of your terminal, and set
your attributes accordingly.
Uses the EIA-232 interface
protocol.
Uses the EIA-232 interface
protocol.
75