Multiboot - IBM H80 User Manual

MultiBoot

Multiboot allows you to select a method for booting the system.
Multiboot
1 Select Software
2 Software Default
3 Select Install Device
4 Select Boot Devices
5 OK Prompt
6 Multiboot Startup <OFF>
===>
Select Software
If this option is supported by the operating system, the names of the operating system
installed are shown. This option might not be supported by all operating systems.
If you are running AIX, and you receive the following message:
No Operating System Installed
This indicates that information in nonvolatile storage could have been lost, as would
happen if the battery had been removed. To re-create this value, run the bootlist
command under AIX with the appropriate parameters. See the bootlist command in
your AIX documentation.The AIX Documentation library is available at the following Web
address: http://www-1.ibm.com/servers/aix/library/. Select Technical Publications. AIX
documentation is also contained on the AIX Documentation CD. The documentation is
made accessible by loading the documentation CD onto the hard disk or by mounting
the CD in the CD-ROM drive.
Software Default
If this option is supported by the operating system, you can select the default operating
system to start the system. This option might not be supported by all operating
systems.
Select Install Device
Produces a list of devices, such as the CD-ROM, from which the operating system may
be installed. Select a device, and the system searches that device for an operating
system to install.
68
User's Guide
.------.
|X=Exit|
'------'