Hardfile Attached To Pci Scsi Raid Adapter; Optical Media; Diskette Format - IBM H80 User Manual

This task can be run directly from the AIX command line. See the following command
syntax: diag -c -d deviceName -T "format [-s* fmtcert | erase -a {read |
write}] [-F]"
Flag
fmtcert Formats and certifies the disk.
*
-F
Note: The Erase Disk option in command line mode uses default values. To selectively

Hardfile Attached to PCI SCSI RAID Adapter

This function formats the physical disks attached to a PCI SCSI RAID adapter. This
task can be run directly from the AIX command line. See the following command
syntax: diag -c -d RAID adapterName -T "format {-l chId | -A }"
Flag
-l
-A

Optical Media

This function formats the optical media attached to a PCI SCSI RAID adapter.
v Optical Media Initialize
Formats the media without certifying. This function does not reassign the defective
blocks or erase the data on the media. This option provides a quick way of formatting
the media and cleaning the disk.
Note: It takes approximately one minute to format the media.
v Optical Media Format and Certify
Formats and certifies the media. This function reassigns the defective blocks and
erases all data on the media.
This task can be run directly from the AIX command line. See the following command
syntax: diag -c -d deviceName -T "format [-s {initialize | fmtcert} ]"
Option Description
initialize
fmtcert Formats and certifies the media

Diskette Format

This selection formats a diskette by writing patterns to it.
Description
Available in no-console mode only.
Force the disk erasure even if all blocks cannot be erased due to errors
accessing grown defect map.
read or write, use the diag command in console mode.
Description
Physical disk channel/ID. (An example of a physical disk channel/ID is 27,
where the channel is 2 and the ID is 7.)
All disks
Formats media without certifying
Chapter 6. Introducing Tasks and Service Aids
101