Language Selection Menu - IBM H80 User Manual

v Power Control Network Utilities Menu
This menu allows the user to do a lamp test on the operator panels and display, or
change the I/O type.
98. Return to Previous Menu
1>
– Lamp Test for all Operator Panels
Selecting this option tests the operator panel indicators as follows:
Operator Panel Location
Secondary I/O drawers
– Display I/O Type
This option displays the I/O type and other data, on the operator panels of the
secondary I/O drawers (blinks in one-second intervals). The I/O type is always
shown as two digits in the upper-right corner of the display. All secondary I/O
types are 84. Nothing displays on the primary I/O drawer operator panel. After
20-30 seconds, the Power Control Network Utilities Menu redisplays on the
console.
– Change I/O Type
Use this option to change the I/O type of the primary I/O drawer or secondary I/O
drawer after a service action or configuration change if the I/O type is incorrect. If
this option is chosen, you are asked to make two entries.
1. For the I/O drawer address (drawer number), type:
2. For the I/O type, type:
If you enter an invalid value, a failure message displays on the console. The
Power Control Network Utilities Menu then redisplays on the console.

Language Selection Menu

The service processor menus and messages are available in various languages. This
menu allows a language to be selected in which the service processor and system
firmware menus and messages are displayed.
36
User's Guide
POWER CONTROL NETWORK UTILITIES MENU
1. Lamp Test for all Operator Panels
2. Display I/O Type
3. Change I/O Type
Primary I/O drawer
- 1 for primary I/O drawer.
- 2 for the secondary I/O drawer.
- 85 for the primary I/O drawer.
- 84 for the secondary I/O drawer.
Lamp Test Results
Indicators blink on and off for approximately 30 seconds.
Indicators come on and stay on for approximately 30 seconds.