Table of Contents
Advertisement
3
Press the ENTER key. A blinking question mark (?)
appears.
Emulation
? PCL 6
4
Select KPDL or KPDL (AUTO) using the
Emulation
? KPDL
5
Press the ENTER key.
6
Press the
key. The message display changes to
that shown below. If >Alt. Emulation is displayed
when the KPDL (AUTO) emulation is selected, press
the
or
key to change it.
>Print KPDL Errs
OFF
7
Press the ENTER key. A blinking question mark (?)
appears.
>Print KPDL Errs
? OFF
8
Select On using the
>Print KPDL Errs
? ON
9
Press the ENTER key.
10
Press the MENU key. The message display returns to
Ready.
or
or
key.
Setting Default Font
You can select the default font for the current interface. In ad-
dition to the internal fonts, all fonts that are downloaded to
the printer memory, or fonts stored on a memory card or op-
tion hard disk can be selected as the default font.
You can also set the type and pitch for Courier and Letter
Gothic.
key.
Selecting the Default Font
1
Press the MENU key.
2
Press the
pears.
Font
3
Press the
or
>Font Select
Internal
To select an option font, press the ENTER key while
>Font Select > is displayed. Press the
key repeatedly until the message display indicates
Option. This operation is possible only when option
fonts are installed in the printer.
4
Press the
>> I000
The letter before the number indicates the type of
font as follows:
Letter
I
S
M
H
O
5
Press the ENTER key. A blinking question mark (?)
appears.
>>?I000
6
Press the
font number appears. For font numbers of the inter-
nal fonts, see
Chapter 1 Using the Operator Panel
or
key repeatedly until Font > ap-
>
key to select an internal font, press the
key repeatedly until Internal appears.
>
key.
Description
Internal fonts
Soft (download) fonts
Fonts in an option memory card
Fonts in a RAM disk or hard disk
Fonts in an option ROM
or
key repeatedly until the desired
List of Fonts on page A-1
or
.
1-27
Advertisement
Table of Contents
