Table of Contents
Advertisement
Paper Handling
This section explains the following topics:
•Setting Paper Size
•Setting Paper Type
•Adjusting Print Density
•Setting MP Tray Mode
•Selecting Paper Source
•Setting Duplex Printing
•Overriding A4 and Letter Size Difference
Setting the Paper Size
Set the paper sizes according to the sizes of paper to be set in
the paper cassette and the MP tray. This setting is made
with the paper size dial for the paper cassette and the opera-
tor panel for the MP tray, respectively.
If they do not match, printing will not be made on the correct
size paper when automatic paper size selection is made by
the application software (printer driver).
Setting the Paper Cassette
In addition to the standard A5
feed), A4R
(short-edge feed), B4
paper of non-standard sizes (OTHER) can be fed into the pa-
per cassette of this printer
For details about the adjustment of the paper guides and pa-
per stopper inside the paper cassette, see the Installation
Guide supplied with the printer.
NOTE
If the paper size dial is not properly adjusted to the actual paper
size, printer trouble such as paper jam may occur.
1
Pull out the paper cassette from the printer and turn
the paper size dial to the paper size you set.
2
Adjust the paper guides and paper stopper inside
the paper cassette to the size of the paper to be used
and load the paper into the cassette. Replace the
cassette into the printer.
Standard paper sizes are automatically detected by
the printer. For non-standard paper sizes, see the
following section Setting Non-Standard Paper Size .
, B5
, A4
(long-edge
, and A3
size paper,
Chapter 1 Using the Operator Panel
Setting Non-Standard Paper Size
Use the following procedures to set a paper size for non-stan-
dard size paper from the operator panel.
1
Press the MENU key.
Press the
or
2
Handling > appears.
Paper Handling >
3
Press the
key.
4
Press the
or
Size > appears. If option paper feeders are added,
Cassette1 Size will appear for the standard pa-
per cassette and Cassette2 Size to Cassette5
Size will appear for the option paper feeders.
>Cassette Size >
Custom
5
Press the ENTER key. A blinking question mark (?)
appears.
>Cassette Size
? Custom
6
Press the
or
The following paper size are displayed.
A4
Executive
Letter-R
Letter
Legal
Ledger
A3
B4
Custom
C4
Oficio II
Folio
8K
16K
C5
A5
B5
ISO B5
A4-R
7
Press the ENTER key. Set the unit of measurement
as described in the next section if you have selected
Custom.
key repeatedly until Paper
key repeatedly until >Cassette
key to select desired paper size.
1-15
Advertisement
Table of Contents
