Setting The Default Font - Kyocera Mita FS-9500DN Operation Manual

10
To change the pen width, press the 2 key, then press
the ENTER key. A blinking cursor appears at the width
value.
>>Pen(1) Width
02 dot(s)
Press the 3 or 4 key repeatedly until the desired pen
width in dots (00 to 99) appears. When the desired pen
width is displayed, press the ENTER key.
11
To set the KC-GL page size, press the 1 key, then
press the 3 or 4 key until >KC-GL Page Set is dis-
played.
12
To change the page size, press the ENTER key. A
blinking question mark (?) appears.
>KC-GL Page Set
? [SPSZ]
Press the 3 or 4 key repeatedly until the desired page
size (A2, A1, A0, B3, B2, B1, B0, and SPSZ) appears.
When selecting SPSZ, printing will be done with the
paper size specified by the PRESCRIBE SPSZ
command. For details, see
CD-ROM.
13
Press the ENTER key to set the page set you just se-
lected.
14
Press the MENU key. The display returns to Ready.

2.2.6 Setting the Default Font

You can select the default font for the current interface. In addi-
tion to the internal fonts, all fonts that are downloaded to the
printer memory, or fonts stored on a memory card, hard disk, or
option ROM, can be selected as the default font.
In this menu, you can also set the type and pitch for Courier and
Letter Gothic; as well as print a font list.
Selecting the Default Font
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Font > appears.
Font
Programming Manual in the
>
Chapter 3 Using the Operator Panel
3
Press the 2 key to select an internal font, press the 3
or 4 key repeatedly until Internal appears.
>Font Select
Internal
To select an option font, press the ENTER key while
> Font Select > is displayed. Press the 3 or 4 key
repeatedly until the
Option.This operation is possible only when option
fonts are installed in the printer.
4 Press the 2 key.
>> I000
The letter before the number indicates the type of font
as follows:
Letter
I Internal fonts
S Soft (down load) fonts
M Fonts in an option memory card
H Fonts in a RAM disk or hard disk
O Fonts in an option ROM
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>>?I000
6
Press the 3 or 4 key repeatedly until the desired font
number appears. For font numbers of the internal
fonts, see List of Fonts on page
>Font Select
Internal
7
When the desired font is displayed, press the ENTER
key.
8
Press the MENU key. The message display returns to
Ready.
>
message display indicates
Description
A-1.
>
3-24