Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
>Private/Stored
?Harold
6
Press the
or
name (Arlen, in this example).
>Private/Stored
?Arlen
7
Press the ENTER key. The user name and the job
name (Agenda, in this example) entered in the
printer driver appear with a blinking question mark
(?).
>Arlen
?Agenda
8
Press the
or
9
Press the ENTER key. The ID input line appears.
Enter the four-digit access code entered in the print-
er driver and press the ENTER key. To enter the ID,
press the
or
ber to be changed and then enter the correct number
by pressing the
In printing a stored job, the access code must be en-
tered in this step only when it has been set on the
printer driver.
>Agenda
ID
10
You can set the number of copies to be printed. To
increase the copy count, press the
the copy count, press the
>Agenda
Copies
11
Press the ENTER key to finalize the copy count. The
printer prints the specified number of copies for the
job.
Deleting a Private/Stored Job
1
Follow steps 1 through 8 in the above section.
2
When the title of the job to be printed is displayed
(Agenda, in this example), press the ENTER key. En-
ter the four-digit access code entered in the printer
driver and press the ENTER key.
1-38
key to display the desired user
key to display the desired job title.
key to move the cursor to the num-
or
key.
0000
key; to decrease
key.
001
>Agenda
Copies
3
Press the
key repeatedly until Delete appears
for the number of copies.
>Agenda
Delete
4
Press the ENTER key. The private job is deleted
from the hard disk.
Printing a Code Job
KM-NET Job Manager
Install the KM-NET Job Manager software from the Kyocera
Mita Digital Library CD-ROM supplied with the printer. To
do this, from the CD-ROM Main Menu, select Printer Utilities
> Install KM-NET Job Manager.
1
Browse through Windows Start > Programs > KYO-
CERA MITA > KM-Net > Job Manager.
2
Enter the password for the software. Job Manager
will start.
3
Click the Add printer icon (below). Select the Local
or Network port.
NOTE
If you use the local parallel port to connect to the printer, make
sure that the printer driver is set to print to a local port. To check
this out, click the Details tab of the printer Properties, and note
the Print to the following port setting.
Add printer
icon
4
Follow the wizard until the Select printer dialog box
is reached. When the printer is found in the Printer
List, click (highlight) it, then Finish.
001
Advertisement
Table of Contents
