Configuration; Setting Page Protect Mode; Setting Linefeed (Lf) Action; Setting Carriage-Return (Cr) Action - Kyocera Mita Ecosys FS-6020 Operation Manual

Configuration

This section explains the following topics:

•Setting Page Protect Mode

•Setting Linefeed (LF) Action

•Setting Carriage-Return (CR) Action

•Setting Wide A4
•Verifying Total Printed Pages
•Resetting Remaining Toner Counter
•Selecting Message Language
•Setting Automatic Form Feed Timeout
•Turning Off the Sleep Timer
•Setting Sleep Timer
•Resetting Printer
•Resource Protection
•Setting Alarm (Buzzer)
•Setting Auto Continue
•Setting Auto Continue Recovery Time
Setting Page Protect Mode
Although Auto is the default setting and this menu does not
usually appear, Page Protect will be forcibly set to On if a
Print overrun Press GO error occurs due to insufficient
printer memory. Be sure to return this setting to Auto in or-
der to maintain high printer memory efficiency. This can be
done as follows.
1 Press the MENU key.
2 Press the or
appears.
Page Set
3 Press the key.
4 Press the or
Protect appears.
>Page Protect
On
5 Press the ENTER key. A blinking question mark (?)
appears.
>Page Protect
? On
6 Press the or
pears.
>Page Protect
? Auto
key repeatedly until Page Set >
>
key repeatedly until >Page
key repeatedly until Auto ap-
Chapter 1 Using the Operator Panel
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Setting Linefeed (LF) Action
This procedure instructs the printer what to do when it re-
ceives a linefeed code (character code 0AH).
1 Press the MENU key.
2 Press the or
appears.
Page Set
3 Press the key.
4 Press the or
appears.
>LF Action
LF only
5 Press the ENTER key. A blinking question mark (?)
appears.
>LF Action
? LF only
6 Press the or
feed action appears.
A linefeed is performed. (default)
LF only
A linefeed and carriage return are
CR and LF
performed.
The linefeed is ignored.
Ignore LF
7 When the desired action is displayed, press the
ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Setting Carriage-Return (CR) Action
This procedure instructs the printer what to do when it re-
ceives a carriage-return code (character code 0DH).
1 Press the MENU key.
key repeatedly until Page Set >
>
key repeatedly until >LF Action
key repeatedly until desired line-
1-51