›
To switch off the ventilation shift the rocker switch into the horizontal position
.
WARNING
If you or a passenger have limited pain and/or temperature sensitivity, e.g.
caused by medication, paralysis or because of chronic illness (e.g. diabetes),
we recommend that you consult your physician before using the ventilated
front seat.
CAUTION
Do not kneel on the seats or otherwise apply pressure at specific points to
■
avoid damaging the electronic seat elements or the fan.
The fan is located underneath the front seat cushion. Do not place any objects
■
in this area - it may damage the fan.
Do not clean the seats using moisture
■
heated seats.
Note
The ventilation should only be switched on when the engine is running. This
■
has a significant effect of saving on the battery capacity.
We do not recommend using the front seat ventilation and heating at the same
■
time. Using the ventilation to cool the seat surface considerably reduces the
heating capacity, at the same time affecting the ability of the control unit to de-
tect the right seat surface temperature.
Head restraints
ä
Introduction
This chapter contains information on the following subjects:
Adjusting, removing and installing a head restraint
Middle rear head restraint
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of your head.
The position of the front and rear outer head restraints is adjustable in height.
The middle rear head restraint is adjustable in two positions.
70
Using the system
» page
172, Fabric covers on electrically
The head restraints must be adjusted to match the size of the seat occupant. Cor-
rectly adjusted head restraints together with the seat belts offer effective protec-
tion for the occupants
» page
WARNING
The head restraints must be correctly adjusted in order to offer effective
■
protection for the occupants in the event of an accident.
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the rear head restraint must not be in the
■
lower position.
Adjusting, removing and installing a head restraint
Ð
Fig. 58 Head restraint: adjusting/removing
ä
First read and observe the introductory information and safety warn-
ings
on page 70.
Adjusting the height of a head restraint
›
Grasp the side of the head restraint with both hands and push it upwards as
required
» Fig. 58
- .
›
To move the head restraint downwards, press and hold the safety but-
ton
» Fig. 58
- with one hand and press the head restraint downwards with
70
the other hand.
71
Removing and installing a head restraint
›
Pull the head restraint up out of the seat backrest as far as the stop (for the
rear head restraints fold the seat backrest forward).
›
Press the locking button in direction of the arrow
head restraint out.
141, Correct seated position.
» Fig. 58
- and pull the
Ð
£