Voice Control - Skoda Superb Owner's Manual

›
Use the device that is to be connected to search for available Bluetooth
ces.
›
Select the hands-free system (as standard "SKODA_BT") from the list of found
devices.
›
Enter the password on the device being connected and follow any instructions
given on this device or in the information display.
›
Enter the desired Internet address in the Internet browser. The operating sys-
tem requests the entry of the telephone number for the internet access (de-
pending on the operator, usually "*99#").

Voice control

Dialogue
The period of time during which the system is ready to receive voice commands
and to carry them out is called a dialogue. The system gives audible feedback and
guides you if necessary through the relevant functions.
Optimum understanding of the voice commands depends on several factors.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
It is recommended to speak louder at higher speeds, so that the tone of your
voice is louder than the increased surrounding noise.
›
During the dialogue, limit additional noise in the vehicle, e.g. passengers talking
at the same time.
›
Do not speak, if the system makes an announcement.
The microphone for voice control is inserted in the moulded headliner and direc-
ted to the driver and front passenger. Therefore the driver and the front passen-
ger can operate the equipment.
Entering a phone number
The telephone number can be entered as a continuous series of individually spo-
ken digits (the whole number at once) or in the form of digital blocks (separated
by short pauses). After each order of digits (separation through brief voice pause)
all of the digits detected up to now are repeated by the system.
The digits 0 - 9, symbols +, , # are permitted. The system detects no continuous
digit combinations such as twenty-three, but only individually spoken digits (two,
three).
1)
Not valid for vehicles with the Columbus navigation system.
®
devi- Activating voice control - GSM II
›
by briefly pressing the button
wheel » page 127, Operating the phone on the multifunction steering wheel,
›
by briefly pressing the button
Deactivating voice control - GSM II
If the system is currently playing a message, the message that is currently being
played will have to be stopped:
›
by briefly pressing the button
Ð
›
by briefly pressing the button
If the system expects a voice command, you can end the dialogue yourself:
›
with the CANCEL voice command;
›
by pressing the button
›
by briefly pressing the button
Activating voice control - GSM III
The dialogue can be started at any time by pressing the button
function steering wheel
Deactivating voice control - GSM III
If the system is currently playing a message, you will need to end the message
currently being played by pressing the
wheel.
If the system expects a voice command, you can end the dialogue yourself:
›
with the CANCEL voice command;
›
by briefly pressing the button
Note
The dialogue of an incoming call is immediately interrupted.
■
The voice control is only possible in vehicles fitted with a multifunction steering
■
wheel with telephone control or a phone mount and adapter.
On vehicles which are factory-fitted with the Columbus navigation system, it is
■
only possible to operate the voice control for the telephone via this device
dienungsanleitung des Navigationssystems Columbus.
on the multifunction steering
1
on the adapter » Fig. 131
1)

on the adapter 1) ,

on the multifunction steering wheel.
1
on the adapter ;
1)

on the multifunction steering wheel.
1
1) .
button on the multifunction steering
1
on the multifunction steering wheel.
1
Communication
on page 130.
on the multi-
1
» Be-
Ð
135