Changing the bulb for the main beam
›
Open the bonnet.
›
Remove the rubber cover
» Fig.
1
›
Push the circlips
together and unhook to the side.
B
›
Remove the holder
.
C
›
Remove the faulty bulb from the holder and insert a new one.
›
Insert the rubber cover.
Installation is carried out in the reverse order.
Changing the bulb for the low beam
›
Open the bonnet.
›
Remove the rubber cover
.
2
›
Turn the connector with the bulb in an anti-clockwise direction up to the stop
and remove
» Fig.
187.
›
Replace the lamp, insert the connector with the new bulb and turn in a clock-
wise direction to the the stop.
›
Insert the rubber cover.
Fog lights and daylight driving lights
Fig. 188 Front bumper: Cover/fog lights with daylight driving lights
ä
First read and observe the introductory information and safety warn-
ings
on page 210.
Replacing bulbs
›
Grasp the cover in the areas marked by the arrows
›
Insert your hand into the opening left by the cover and press the lug
» Fig. 188
- .
3
›
Remove the front fog lamp.
212
Do-it-yourself
186.
» Fig. 188
- and remove it.
›
Turn the connector
(daylight driving light) or
1
an anti-clockwise direction up to the stop and remove.
›
Replace the lamp, insert the connector with the new bulb and turn in a clock-
wise direction to the the stop.
›
To re-install the fog light, first of all place the fog light with the lug on the side
opposite the license plate.
›
Press in the fog lamp on the side closest to the license plate. The lug must en-
gage firmly.
›
To reinstall the cover, first of all insert part of the cover starting on the side fac-
ing the fog light. Then press the cover on the side closest to the license plate.
The cover must engage firmly.
Ð
(fog light) with the bulb in
2
Ð