Default Gateway - Planet ADN-4100 User Manual

The following table describes the parameters in this page.
Field
Destination Network
Address
Subnet Mask
Use Gateway IP
Address
Use Interface
Note:
You can enter the gateway IP address of the device in the Use Gateway IP
Address field or set the User Interface, but cannot apply the two settings at
the same time.
Click Apply to save the settings.

3.3.11.2 Default Gateway

Choose Advanced > Routing and click Default Gateway. The page as shown in
the following figure appears:
The destination IP address of the device.
The subnet mask of the destination IP address.
The gateway IP address of the device.
Select the interface of the static routing used by the
device from the drop-down list.
77
Description