Hardware Installation - Planet ADN-4100 User Manual

2

Hardware Installation

Step 1 Connect the LINE interface of the device and the Modem interface of
the splitter with a telephone cable. Connect the phone set to the
Phone interface of the splitter through a telephone cable. Connect the
input cable to the Line interface of the splitter.
The splitter has three interfaces:
Step 2 Connect the LAN interface of the device to the network card of the PC
through an Ethernet cable (MDI/MDIX).
Step 3 Insert one end of the power adapter to the wall outlet and connect the
other end to the POWER interface of the device.
Connection 1: Figure 3 shows the connection of the device, PC, splitter, and
telephone sets, when no telephone set is placed before the splitter. This type of
connection is recommended.
Line: Connect to a wall phone interface (RJ-11 jack).
Modem: Connect to the LINE interface of the device.
Phone: Connect to a telephone set.
Note:
Use the twisted-pair cable to connect the hub or switch.
6