Roland PNC-1860 User Manual page 15

(3) Pull out as much from the roll as needed, and pass the material
from the back of the main unit to the front as shown in the
figure.
At this time, line up the right edge of the material with the
guide lines at the front and rear of the grit roller near the
control panel, and pull the material straight out to the front.
Make sure that the edge of the material lies above the grit
rollers. Also check to make sure that the left and right pinch
rollers can be moved to the left and right edges of the material.
(4) Move the left and right pinch rollers so that they are close to
the respective left and right edges of the material. When using
a material that is wider than 762 mm (30"), move the middle
pinch roller to a position near the center of the left and right
pinch rollers. (The PNC-1210 has no middle pinch roller.)
When doing this, make sure that the grit rollers are under the
pinch rollers.
Seals showing the positions of the grit rollers are affixed to the
areas where the carriage moves. You can use these stickers to
confirm the locations of the grit rollers when the grit rollers
are hidden by the material.
If the pinch rollers are difficult to move, try moving the sheet
loading lever on the back of the unit at the same time.
(5) Lift the sheet loading lever on the back of the unit to lower
the pinch roller and clamp the material.
Lift the sheet
loading levers
Be sure to move the pinch rollers above the grit rollers when securing a material in the unit.
Moving the pinch roller to the area of the grit roller and pressing the
at right to appear. If this occurs, raise the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers.
Reposition the material to match this new alignment, then lower the sheet loading levers to hold the material in place.
(6) To secure the rolled material loaded on the sheet hanger, move the stopper to align it with the material, then tighten the stopper
retaining screw securely.
Rolled material
When using a material
which is narrower than 762
mm (30"), do not lower the
pinch rollers.
key causes the message
SETUP
Pinch roller
Material
Make sure the left and right margins are the same size
Stickers showing the locations of the
grit rollers
Move the pinch
rollers to inside
the edges of the
sheet
Before attempting to move the pinch roller, be
sure to lower the sheet loading lever to raise the
pinch roller.
Change Pinch
Roller Position
Stopper retaining screw
Guide line
Shaft
7