What To Do If - Roland PNC-1860 User Manual

11 WHAT TO DO IF....

11-1 What to do if....
Is the power cord connected correctly?
Is the PNC-1860/1410/1210 power on ?
Is the front cover closed?
Is the PNC-1860/1410/1210 in the temporary
halt state ? Is operation paused?
If connected via the serial port, do the
communication parameters for the PNC-
1860/1410/1210 match those of the
computer ?
Is the computer set up correctly ?
Are the computer and the PNC-1860/1410/
1210 linked with the right cable ?
Are the computer and the PNC-1860/1410/
1210 connected correctly?
Is the interface setting correct?
Is the OS set up correctly ?
Are the application software settings
correctly ?
26
PNC-1860/1410/1210 troubleshooting
Connect the power cord included with the PNC-1860/1410/1210 to the unit,
and plug the other end securely into an electrical outlet (see "3-1
Installation and Connections" on page 3).
Turn on the power.
Close the front cover when performing cutting (see "3-3 Loading a Sheet"
on page 5).
If the screen shown at rights is displayed,
it means that operation is paused.
Follow the steps described in " Pausing Cutting"
To resume cutting, use the
key.To abord cutting, first stop the flow of cutting instructions from the
computer. And use the
key.
At the display menus, make the correct settings for the communication
parameters (refer to "3-4 Selecting the Interface" on page 11).
Check the following items:
• DIP switches
parameters
Read the computer user's manual and set it up correctly.
The type of cable you need is determined by your computer and the software
you are using. Even if the computer is the same, running different software
may require a different cable. Use the cable specified in your software.
Correctly connect the computer and the PNC-1860/1410/1210 (see "3-1
Installation and Connections" on page 3).
At the display menu, make the correct setting for the interface connecting
the computer and the PNC-1860/1410/1210 (refer to "3-4 Selecting the
Interface" on page 11).
Check the following items:
• Output port selection
• Communication Parameters
Check the OS's user's manual and set it up correctly.
Check the following items:
• Output device specifications (select a device name that matches the
instruction system.
If the wrong device is selected an incorrect instruction may be output,
resulting in an error).
• Communication Parameters • Other settings
Check the software user's manual and set it up correctly.
and keys to select "CONT," then press the
and keys to select "STOP," then press the
• Memory switches • Interface board
• Other settings
• Output device selection
• Other settings
PAUSE ON
CONT. STOP VIEW
ENTER
• Communication
• Output port open