Roland PNC-1860 User Manual page 30

MENU
Giving priority to settings from the computer
This is normally set to "IGNORE" when performing cutting. When a
tool-selection instruction (SP instruction) is sent from the computer
TOOL-CNG while this is set to "EGNORE," the SP instruction is ignored and
COMMAND operation continues without pause. When set to "EFFECT," SP exchange
instructions are accepted and operation pauses. If tool change is needed,
open the front cover, change the tool, then press the ENTER key.
To perform cutting at the speed determined by a VS command (tool speed
VS
setting command) sent from the computer, set this to "EFFECT." When
COMMAND
set to "IGNORE," cutting is performed using the values for "** cm/s" and
"UPSPEED" set at the top menu.
To perform cutting at the tool force determined by an FS command (tool
FS
force setting command) sent from the computer, set this to "EFFECT."
COMMAND
When set to "IGNORE," cutting is performed using the values for "** gf"
set at the top menu.
Other setting
ENGLISH,
JAPANESE,
The PNC-1860/1410/1200 is capable of displaying all its menus in
GERMAN,
either of six languages, English, French, German, Spanish, Italian
FRENCH
and Japanese.
SPANISH,
ITALIAN
This sets the type of unit for coordinate values that appear on the display.
UNIT
Set this to "MECHANICAL UNIT" for display in cutting coordinate units
(1 = 0.025 mm), or to "MILLIMETER" for display in millimeters.
This performs an operation check when the PNC-1860/1410/1210 is not
DEMO CUT
working correctly.
This moves the tool up or down. It also moves the tip of the blade in any
UP/DOWN
of four directions (-X, +X, -Y, or +Y).
MOVE
With the tool down, the tool carriage can be moved with the four cursor
keys to cut the sheet.
1 OVER CUT
Cutting results differ as shown in the following figures depending on whether the Overcut function is on or off.
OVER CUT: OFF
2 ROTATE
Whenever you employ the Rotate function (which allows you to rotate a character 90 degrees), the origin will be located at the
material's lower-right.
[0° Rotation]
Y
Origin
22
Explanation
X
Default
IGNORE
IGNORE
IGNORE
ENGLISH
MACHINE
OVER CUT: ON
[90° Rotation]
Page where
explained
23, 24
1 1
1 1
-
-
- -
- -
X
Origin
Y