Using Your Remote Vehicle Starter; Remote Starting Your Vehicle; Entering Your Vehicle While It Is Running Via Remote Start; Preheating Or Precooling The Vehicle's Interior - Code Alarm Procomp Owner's Manual

Using Your Remote Vehicle Starter

Remote Starting Your Vehicle

To activate the remote vehicle start function, press and release the
times within 2 seconds. The system will sound, the parking lights will flash 1 time
and the system will check the vehicle to ensure it is safe to start. If all safety
parameters are correct, the vehicle will start within 5 seconds. The vehicle's
parking lights will turn on (or flash depending on system settings) as a visual
indication that the vehicle has started and is running. Press and hold the
for 3 seconds to turn the vehicle off.
If your vehicle stalls or does not start, the system will pause 3 seconds, then try 3
more times to start the vehicle (a total of 4 attempts). The system will pause 3
seconds between each start attempt. If the vehicle does not start after the 4th
attempt, the system will abort the remote vehicle start process.
Entering the Vehicle while it is Running via Remote Vehicle Start
1. Unlock the vehicle's doors.
2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3. Insert the key into the ignition switch and turn to the ON or RUN position.
4. Press the brake pedal. The remote vehicle starter will disengage and
the vehicle will operate normally.

Preheating or Precooling the Vehicle's interior

Before exiting the vehicle, set the temperature controls to the desired setting and
operation. After the system starts the vehicle, the heater or air conditioner will
activate and heat or cool the vehicle's interior to your setting.

Using the "Quick-stop" Feature

If you want to make a short stop and keep your vehicle running (to keep the
interior warm or cool), the quick-stop feature allows you to do this while keeping
your vehicle secure and your keys with you.
To engage quick stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot off the brake pedal, press and release the
times within 2 seconds. The LED will flash 3 times to confirm quick stop is
entered. If your vehicle has a manual transmission, set the parking brake
after this step to prevent activating manual transmission ready mode.
3. Remove the keys from the ignition and exit the vehicle. Press the
button to lock the vehicle's doors if desired.
NOTE: Do not leave children or animals unattended in the vehicle when using the
quick-stop feature.
8 2012 Audiovox Electronics Corporation. All rights reserved.
button 2
button
button 2