Disarming The Security System; Two Stage Door Unlock (Optional); Eliminating Arm / Disarm Notification Chirps; Using The Progressive Car Finder Feature - Code Alarm Procomp Owner's Manual

Disarming the Security System

To disarm the system press the
indicating the system is disarmed and has unlocked the doors (if equipped and
connected).
NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the
vehicle.

Two Stage Door Unlock (Optional)

If this feature is enabled on your system, pressing the
unlock only the driver's door. Press

Eliminating Arm / Disarm Notification Chirps

System ARM/DISARM chirps can be toggled ON or OFF without entering the
programming feature banks.
1. Turn the ignition ON then OFF.
2. Press and release the valet/programming button 3 times. The system will
respond with 1 chirp for ON or 2 chirps for OFF.

Using the Progressive Car Finder Feature

Use the car finder feature to locate your vehicle. The system will sound 5 times at
low volume, increasing in volume each time the button is pressed.
1 Way Transmitter - Press and release
2 Way Transmitter - Press and release
Using the Personal Protection Alarm (Panic)
Press and hold the button(s) shown below for 3 seconds to activate the personal
protection alarm . During panic mode, the normal function of the transmitter buttons
will be suspended. The transmitter's
unlock the door (if the option is installed). To stop the alarm, press and hold the
button(s) on the transmitter again for 3 seconds. The system will automatically
stop after 30 seconds.
1 Way Transmitter - Press and hold
2 Way Transmitter - Press and hold
4
button. The parking lights will flash 1 time,
button to activate an audible arming response from the
again to unlock the remaining doors.
and
button one time will
.
+ .
buttons can be used to lock and
for 3 seconds.
+ for 3 seconds.
2012 Audiovox Electronics Corporation. All rights reserved.