Using Your Remote Vehicle Starter; Remote Start Ready Mode; Cancelling Remote Start Ready Mode - Code Alarm Elite CA6155e Owner's Manual

Using Your Remote Starter
Remote Start Ready Mode must be enabled if your vehicle is equipped with a
manual transmission.
Remote Start Ready Mode - Manual Transmission Vehicles Only
To activate the remote start function, the system must first be in Remote Start Ready
Mode. Follow the steps below to enter remote start ready mode.
1. While the engine is running by the ignition key;
a.
b.
2. With your foot off the brake pedal, press and release the
activate the remote start. The LED will flash 3 times and the parking
lights will turn on to confirm the system has remote started.
3. Remove the keys from the ignition, the vehicle will remain running.
4. Exit the vehicle and close all vehicle doors.
5. Within 1 minute of step 1, press the
doors. The vehicle will shutdown and sound 2 short chirps then 1 long
chirp to confirm ready mode is set.
Cancelling Remote Start Ready Mode - Manual Transmission Vehicles Only
The system will exit remote start ready mode if any of the following occur:
Open any door
Open the hood or trunk (if connected)
Press the brake
Release the parking brake
Turn the ignition ON
2020 Voxx Electronics Corporation. All rights reserved.
Place the transmission in neutral.
Set the parking brake
button to lock the vehicle's
button to
7