Using Your Remote Vehicle Starter; Remote Start Ready Mode; Cancelling Remote Start Ready Mode - Code Alarm PROFESSIONAL SERIES ca6554 Owner's Manual

Using Your Remote Starter
Remote Start Ready Mode must be enabled if your vehicle is equipped with a
manual transmission.
Remote Start Ready Mode - Manual Transmission Vehicles Only
To activate the remote start function, the system must first be in Remote Start Ready
Mode. Follow the steps below to enter remote start ready mode.
1. While the engine is running by the ignition key;
a.
b.
2. With your foot off the brake pedal, press and release the
times within 2 seconds. The LED will flash 3 times and the parking
lights will turn on to confirm the system has entered quick stop mode.
3. Remove the keys from the ignition, the vehicle will remain running in
quick stop mode.
4. Exit the vehicle and close all vehicle doors.
5. Within 1 minute of step 1, press the
doors. The vehicle will shutdown and sound 2 short chirps then 1 long
chirp to confirm ready mode is set.

Cancelling Remote Start Ready Mode

The system will exit remote start ready mode if any of the following occur:
Open any door
Open the hood or trunk (if connected)
Press the brake
Release the parking brake
Turn the ignition ON
2014 Voxx Electronics Corporation. All rights reserved.
Set the parking brake
Place the transmission in neutral.
button to lock the vehicle's
button 2
7