Vertical Punch (Z-Fold) Position Adjustment; Horizontal Punch (Z-Fold) Position Adjustment - Konica Minolta bizhub C652 User Manual

7

Vertical Punch (Z-Fold) Position Adjustment

Adjust the vertical position of the punched holes for each paper size.
0 Before making any adjustments, create a sample using the punch settings. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Z Folding Unit is installed.
1
Select [Utility/Counter] ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö
[Finisher Adjustment] ö [Vertical Punch (Z-Fold) Position Adjustment].
2
Select the size of paper of which the vertical punched hole position is adjusted.
3
Press [+] or [-] to adjust the punched hole position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.

Horizontal Punch (Z-Fold) Position Adjustment

Adjust the horizontal position of the punched holes for each paper size.
0 Before making any adjustments, create a sample using the punch settings. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Z Folding Unit is installed.
1
Select [Utility/Counter] ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö
[Finisher Adjustment] ö [Horizontal Punch (Z-Fold) Position Adjustment].
2
Press [+] or [-] to adjust the punched hole position while checking the sample.
3
Press [OK].
4
Create a sample, and check the print result.
7-20
System Settings
bizhub C652/C652DS/C552/C452 (Version 2)
7.1