Expert Adjustment - Konica Minolta bizhub C652 User Manual

7.1 System Settings
7.1.7

Expert Adjustment

Make adjustments so that output quality is increased.
%
Press the [Utility/Counter] key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment].
Settings
AE Level Adjustment
Printer Adjustment
Finisher Adjustment
bizhub C652/C652DS/C552/C452 (Version 2)
Configure the initial value for AE (auto exposure). The higher the setting,
the more that the original background is emphasized.
Adjust the starting print position and defective print images caused by pa-
per type features.
d
Reference
The starting print position is factory-adjusted. Normally, you
are not required to change the set values.
Leading Edge Adjustment
Centering
Leading Edge Adjustment (Du-
plex Side 2)
Centering (Duplex 2nd Side)
Erase Leading Edge
Vertical Adjustment
Media Adjustment
Adjust the staple, folding, and punch position of the finisher.
This button appears only when the finisher is installed.
d
Reference
Create a sample in advance, and then adjust them while
checking the sample.
Center Staple Position
Half-Fold Position
Tri-Fold Position Adjustment
Punch Vertical Position Adjust-
ment
p. 7-15
p. 7-15
p. 7-15
p. 7-15
Adjust leading edge erase width.
For details on displaying this item,
contact your service representative.
Adjust the feed direction zoom ratio of
paper types.
For details on displaying this item,
contact your service representative.
p. 7-16
p. 7-16
p. 7-17
p. 7-17
(This item is displayed when the Fin-
isher FS-526 and Saddle Stitcher
SD-508 are installed.)
p. 7-18
(This item is displayed when the Fin-
isher FS-526 and Punch Kit PK-516
are installed.)
7
7-11