Brother P-touch QL-1050 Service Manual page 40

(7) Release the hooks on both sides of the inlet and pull the inlet to the direction of the arrow
as shown in the figure below to remove it.
For the hook on the lower side of the inlet, turn the under cover upside down and press
the hook from the hole on the under cover.
Hole
Fig. 3.1-17 Removing the Power Supply PCB and Main PCB (7)
(8) Pull the inlet out of the hole of the fan to remove it and remove the power supply PCB from
the machine.
Inlet
Under cover
Fig. 3.1-18 Removing the Power Supply PCB and Main PCB (8)
Under cover
Hook
Inlet
Hook
III- 15
Power Supply PCB