9. Set the die cut roll of 62mm x 100mm into the machine and click the "Print
test(62mm 1Label) (C)" button.
10. Measure the top margin of the print result. Set the value in the "Adjust value"
column so that the top margin is 3mm±0.25mm and click the "Apply (2)" button.
11. Click the "Print test(62mm 1Label) (C)" button again and check the print result.
12. Click the "OK" button to close the window.
Note 1: Always make sure to adjust these values following the steps above.
→
→
(continuous
62mm 2Lables
62mm 1Label)
Note 2: The "OK" button is disabled before these three types of adjustment are
completed.
3mm±0.25mm
Printing direction
Fig. 23
21