HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier
Ethernet-based Remote Product Management
•
Trap IP 1 / Trap IP 2 – The Administrator can assign up to two SNMP Trap IP addresses in the
form 000.000.000.000.
•
Trap Version – Use the drop‐down list to select the SNMP Trap as version SNMPv1 or
SNMPv2c.
Click [Submit SNMP] to save these changes, or click [Reset] to revert to the previously assigned
SNMP settings.
4.5.5.3
Config Pages
Click the Config tab, and then select the Amplifier, Utility, or Redundancy hyperlink to continue.
4.5.5.3.1
Config | Amplifier Page
Use this page to configure the communications, operations, and alarms/faults handling for the
amplifier.
At any time, click [Refresh] to update this page and see the most recent data.
Amplifier
•
Attenuation (dB) – Enter an attenuation level, in 0.25 dB steps, from 00.00 to 20.00 dB.
Figure 4-6. Config | Amplifier page
4–17
Revision 6
MN/HPOD.IOM