HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Appendix C
C.3.2 Installing the New Fan Assembly
To re‐install the fan assembly:
Step
Task
1
Visually inspect the exposed SSPA heat sink for any debris/blockage. Use compressed air to
clear/clean if needed.
2
Connect the fan assembly's circular connectors to the SSPA
3
Position the fan assembly onto the SSPA, ensuring proper alignment of the fasteners without
any cable or fan interference.
4
Tighten the four captive fasteners where indicated previously in Figure C-2.
Figure C-3. HPOD Fan Assembly Replacement
Be sure to use an appropriate screwdriver, such as the one provided with the
SSPA, to avoid damaging the fasteners.
C–5
Revision 6
MN/HPOD.IOM