Napoleon BGD36CFNTR Installation And Operating Instructions Manual page 36

6
Purge all gas lines with the glass door of the fireplace
removed or opened. Assure that a continuous gas flow
is at the burner before installing the door.
When lit for the first time, the fireplace will emit a slight
odour for a few hours. this is a normal temporary con-
dition caused by the "burn-in" of internal paints and
lubricants used in the manufacturing process and will
not occur again.
FOR YOUR SAFETY READ bEFORE LIGHTING:
A. This fireplace is equipped with a pilot which must be lit
by hand while following these instructions exactly.
B. Before operating smell all around the fireplace area for
gas and next to the floor because some gas is heavier
than air and will settle on the floor.
C. Use only your hand to turn the gas control knob. never
use tools. If the knob will not turn by hand, do not try to
repair it. Call a qualified service technician. Force or at-
tempted repair may result in a fire or explosion.
D. Do not use this fireplace if any part has been under water.
Immediately call a qualified service technician to inspect
the fireplace and replace any part of the control system
and any gas control which has been under water.
WARNING: The gas valve has an interlock device which
will not allow the pilot burner to be lit until the thermocouple
has cooled. Allow approximately 60 seconds for the ther-
mocouple to cool.
When lighting and re-lighting, the gas knob cannot be turned
from pilot to off unless the knob is depressed slightly.
1. Stop! Read the above safety information on this label.
2. Turn off all electric power to the fireplace.
3. Turn the gas knob clockwise to off.
4. Wait five (5) minutes to clear out any gas. If you smell
gas including near the floor. Stop! Follow "B" in the above
safety information on this label. If you don't smell gas go the
next step.
1. Turn off all electric power to the fireplace if service is to
be performed.
TURN THE CONTROL VALVE TO THE OFF POSITION WHEN HEATER IS NOT IN USE.
W45-0566 / A / 07..06
OPERATION / MAINTENANCE
LIGHTING INSTRUCTIONS
TO TURN OFF GAS
After extended periods of non-operation such as follow-
ing a vacation or a warm weather season, the fireplace
may emit a slight odour for a few hours. this is caused
by dust particles in the heat exchanger burning off. In
both cases, open a window to sufficiently ventilate the
room.
WHAT TO DO IF YOU SMELL GAS:
• Turn off all gas to the fireplace.
• Open windows.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
5. Turn gas knob counter-clockwise to pilot.
6. Depress slightly and hold gas knob while lighting the
pilot with the push button ignitor. keep knob depressed for
one minute, then release. If pilot does not continue to burn,
repeat steps  through 5.
7. With pilot lit, depress and turn gas knob counter-clock-
wise to on.
8. If equipped with remote on-off switch/thermostat, main
burner may not come on when you turn valve to on. Remote
switch must be in the on position to ignite burner.
9. Turn on all electric power to the fireplace.
2. Push in gas control knob slightly and turn clockwise to
off. Do not force.
gas knob