Napoleon BGD36CFNTR Installation And Operating Instructions Manual page 31

COMMON FINISHING
GLOWING EMbERS
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (# & #). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges of
the fibre hairs will glow. the ember material will only glow
when exposed to direct flame; however, care should be
taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. pHazER
when exposed to direct flame. Use only certified "glowing
embers" and pHazER
TM
logs available from your napoleon
dealer.
CHARCOAL EMbERS
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine dust
found in the bottom of the bag should not be used.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to
be placed on the burner.
LOGO PLACEMENT
½"
LOGO
½"
bGD36CF FINISHING
LOG PLACEMENT
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments burn
in during the heat activated curing process.
TM logs glow
Remove the backing of the logo
supplied and place on the glass
viewing door, as indicated.
FIGURE 82
FIGURE 83
SIDevIeW
1. Place the back log (#) onto the log
support tray and in front of the tabs. The
tabs maintain an air space between the log
and firebox back to facilitate combustion air
flow. Ensure that the back of the log rests
against the brackets on the back wall of
the firebox.
tAB
FIGURE 84
2. Move the two small logs (# & #) into position, lining up
the studs located on the burner with the holes on the bottom
of the logs. Ensure that the small logs sit flat on the burner.
3. Place the bottom of the left crossover log (#4) against
the left firebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
4. Position the base end of the center log (#5) against the
middle grate post with the other end of the log resting in the
pocket of the left crossover log.

FIGURE 85
FIGURE 86
FIGURE 87
W45-0566 / A / 07..06