Napoleon BGD36CFNTR Installation And Operating Instructions Manual page 32


5. Place the bottom of the right crossover log (#6) against
the right firebox side and pulled forward to the grate. The top
of the log should rest in the pocket provided on the center
log (#5).
DOOR OPERATION
FIGURE 89
bGD42CF FINISHING
DOOR INSTALLATION / REMOVAL
Open the Valve Access Door. While holding the door se-
curely, release the 4 latches along the top of the door. Tilt
the door forward and lift off of the two brackets at the bot-
tom of the door. When replacing the door, rest the the door
on the brackets ensuring that lip of the brackets rest in the
groove in the bottom edge of the door. Tilt the door forward
into place and secure with the 4 latches.
DOOR LATCH
W45-0566 / A / 07..06
FIGURE 88
The grate for this fireplace has been removed for shipping
purposes.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the
two pins as illustrated.
To access the
lower door
latch, open the
Valve Access
FIGURE 91
Door as
illustrated
on page .
Release the
pHazER
top and bottom
door latches,
poleon Fireplaces, provide a unique and realistic glowing
located at the
effect that is different in every installation. Take the time
right side of
to carefully position the glowing embers for a maximum
the door.
glowing effect. Log colours may vary. During the initial use
of the fireplace, the colours will become more uniform as
colour pigments burn in during the heat activated curing
process.
FIGURE 92
. Place the cutout in the bottom of log # behind the pilot
assembly. Rest the log against the back wall of the firebox.
FIGURE 93
DOOR BRACKET
. Move the two small logs (# & #) into position, lining
up the studs located on the burner with the holes on the
bottom of the logs.
FIGURE 90
GRATE INSTALLATION
GRATE
LOG PLACEMENT
logs and glowing embers, exclusive to na-
tm
#1
#2
#3