Napoleon BGD36CFNTR Installation And Operating Instructions Manual page 33

FIGURE 94
GLOWING EMbERS
. Tear the glowing embers into pieces and place along the
front row of ports covering all of the burner area in front of
the small logs (# & #). Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will
only glow when exposed to direct flame; however, care
should be taken to not block the burner ports. Blocked
burner ports can cause an incorrect flame pattern, carbon
deposits and delayed ignition. pHazER
exposed to direct flame.
FIGURE 95
#4
4. Cradle the notch on the bottom of the left crossover log
(#4) around the left side of the grate and the top into the
pocket provided on the back log. Place the end of the cen-
ter log (#5) against the grate, as shown, with the other end
of the log resting in the pocket of the left crossover log.
OPTIONAL bLOWER INSTALLATION
bGD36CF ACCESSING THE bLOWER
1. Remove the valve access door using the instructions on
Pg # of this manual.
2. Open the main door.
3. Carefully remove the logs.
4. Remove the 7 screws illustrated in Fig. 98 and lift out
the log support.
logs glow when
tm
#5
FIGURE 97
FIGURE 96
5. Place the bottom of the right crossover log (#6) against
the right side of the grate. Place the top into the pocket
provided on the center log (#5).
5 . R e m o v e
FIGURE 98
the 8 perimeter
screws as illus-
rated in Fig. 99
and lift out the
b u r n e r b a s e .
( T h e g a s l i n e
flex-connector
should provide
sufficent move-
ment to permit
shifting the burn-
er assembly to the side)

#6
W45-0566 / A / 07..06