Scanner Unit Disassembly; Hinge Removal - Epson Stylus CX3100 Service Manual

EPSON Stylus CX3100/3200

4.3 Scanner Unit Disassembly

This section describes the disassembly procedure for the scanner unit. Figure 4-7
shows the disassembly procedure flowchart for the scanner unit.

Hinge Removal

Upper Housing
Motor Unit Removal CCD Module Removal
Figure 4-7. Flowchart (2)
Perform disassembly and assembly of the scanner unit in an
C A U T I O N
environment free from dust. You are advised to work in a clean
room or on a clean bench, if possible.
Disassembly and Assembly
START
Removal
Panel Circuit Board
Removal
Scanner Unit Disassembly
4.3.1 Hinge Removal
1. Remove the scanner unit. (Refer to
2. Remove the document cover.
3. Remove the four screws (CBP-Tite 3x10 F/Zn) securing the hinge to the scanner unit.
NOTE: Screw tightening torque: 0.5-0.7 Nm
CBP-Tite 3x10 F/Zn
Figure 4-8. Screws securing the Hinge
4. Remove the hinge.
Revision A
"Scanner Unit Removal" on page 38)
40