Upper Housing Removal - Epson Stylus CX3100 Service Manual

EPSON Stylus CX3100/3200

4.3.2 Upper Housing Removal

1. Remove the scanner unit. (Refer to
2. Remove the hinge. (See "Hinge Removal" on page
3. Remove the two screws (CCP-Tite 3x8 F/Zb) securing the upper housing to the
scanner unit.
NOTE: Screw tightening torque: TBD
CCP-Tite 3x8 F/Zn
Figure 4-9. Screws securing the Upper Housing
4. Disengage the two hooks fastening the upper housing and lower housing.
Disassembly and Assembly
"Scanner Unit Removal" on page 38)
40)
5. Open the upper housing by lifting it from the rear.
6. Insert your hand through the opening and disconnect the harness for the panel from the
connector on the panel circuit board.
Scanner Unit Disassembly
Hook
Figure 4-10. Hook Position
Figure 4-11. Harness Disconnection
Revision A
41