Cyclic Error - Oki 18 Service Manual

(5) Cyclic error

Image Drum
Developing roller
Toner supply roller
Charging roller
Cleaning roller
Transfer roller
Heat roller
Pressure roller B
Notes:
1. After replacing the image drum cartridge, set the printer in the user maintenance mode by turning the power on
while pressing the MENU key, and reset the drum counter. (Refer to User's Manual.)
2 After replacing the fusing unit assy, set the printer in the engine maintenance mode by turning the power on while
pressing the FORM FEED and ENTER keys, and reset the fuser counter. (Refer to See 4.1.)
Copyright 1998, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner
Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide OKIPAGE 18/18n
Chapter 6 Troubleshooting Procedures
Cycle
3.71" (94.2 mm)
2.05" (52.1 mm)
3.24" (82.24 mm)
1.37" (34.7 mm)
1.17" (29.8 mm)
2.28" (58 mm)
3.46" (88 mm)
3.46" (88 mm)
Remedy
Clean or replace the image drum unit.
Replace the image drum cartridge.
Replace the image drum cartridge.
Replace the image drum cartridge.
Replace the image drum cartridge.
Replace the transfer roller.
Replace the fusing unit assy.
Replace pressure roller.
Page: 101