Cycle Print Mode; Setting The Interval Between Scanning And Operations - Kodak 2400DSV-E Operator's Manual

Cycle Print mode

Setting the interval
between scanning
operations
Value
Period (sec.)
3-16
This mode automatically scans the next image following a preset period
of time. Images are manually loaded onto the carrier glass in between
cycles.
The Cycle Print setting must be enabled. If you want to use Cycle Print
mode, connect your Kodak Service Representative.
NOTE: This function is only available when using the Printer mode.
The chart below provides the time intervals that can be set between
scanning operations. The time interval is based upon how much time it
takes you to move, for example, a roll of film from frame-to-frame. Refer
to this table when making a value selection.
1 2 3
0.5 1.0 1.5
To set the time interval:
1. Press the Multi-Print key to change the value to "A". This enables the
Cycle Print mode.
2. Press the Multi-Print key to set the interval of time between scan
operations. Refer to the table above for the time interval value.
3. After entering the desired value, press the Memory Input key to store
the selected interval setting.
4 5 6
2.0 2.5 3.0
Memory Input key
7 8 9
3.5 4.0 4.5
A-61316 September 2004
0
5.0